The giveaway winners were selected at random. Only folks who submitted a completed (or nearly completed) workbench were eligible for the Moxon and the Veritas Surface Clamp. But the entire Guild was eligible for the Lie Nielsen Saw. Congrats to our winners as well as everyone who completed a workbench. Just having a Roubo in your shop is almost a prize in and of itself!

The Benchcrafted Moxon vise clamps to any bench, raising your workpiece to a convenient height and hold it rock-solid. If you cut dovetails and other joints by hand, this is a vise that will completely change your experience in the shop. Fast and effortless, the Moxon vise makes joinery a pleasure. The Benchcrafted Moxon vise kit goes to Paul Loney!

Veritas Surface Clamps are small bench hold-downs, just the thing for holding the loose end of a long board to a bench skirt or a board jack. They’ll fit anywhere you can drill a 3/4″ hole up to an 1-3/8″ deep. The Veritas Surface Clamp goes to Steven Moll!

The Carcass Saw is used for precise cuts across the grain, cutting tenon shoulders, and defining the edges of a dado. It has 14 points per inch, filed crosscut, for cutting quickly, yet accurately and smoothly. The Lie Nielsen cross-cut saw goes to Trevor Braun!